I am eventually planning on putting the covers on and cheese graters so that is why I left the tabs, ignition and solenoid exposed. I am actually going to make another one and fine tune it. Maybe make it a little wider so then the solenoid would go behind the box. I am kind of taking a liking to the diamond plate as well so I might not put the covers back on. We shall see. I have about 700 miles on it since I put the system in place. It runs really good. A lot more torque with the pod filters. As you know I have been screwing around with this whole vacuum/mixture problem with the carbs. There is a definite difference between the performance of the TBS needles and the stock needles. I am going to put the TBS needles back in this weekend, replace all the vacuum components again and put some gasket sealer on under the carb cap after I replace the needles and hope that I get somewhere with it...
