Quote:

Very nice! Mine are on order.

Thanks. Aside from cost, I don't know why they don't come from the factory this way. A few install notes for ya:

--Your kit will include a pair of 3-wire pigtails containing diodes to prevent current reversing. Be sure to tug gently on the wires to make sure they are solid. One of my pigtails was loose and the wires came out (a replacement pigtail was mailed promptly).
--Use thin stiff wire (I used bolt security wire) to pull the single wire through the turn signal stalks.
--Using the supplied silicone, attach each LED ring to the white plastic plate that sits behind the turn signal bulb. The instructions say to glue it to the inside of the lens which I didn't want to do 'cause it would obscure the bulb.
--Except for the 2 T-taps (ScotchLoks) that are made to the wiring behind the license plate, make all your other connections inside the tail lamp housing itself. That way the taps are protected from the elements. It's a close fit in there, but worth the extra patience it requires.
--Use silicone dielectric grease on all connections.