Quote:

Camshaft bearing caps to head bolts 10Nm
NOTES: Lubricate threads with engine oil. Specific tightening sequence. Note that there are three bearing caps per camshaft. Tighten the far right cap first (right side of bike), then tighten cap on the far left, then tighten the middle cap. Do this for each camshaft.

Camshaft oil feed pipe to bearing cap bolts 8Nm



Moe,
As I was reading through the book, I saw no mention of this tightening sequence. I was under the assumption that when I go to replace the caps that I should start them all and then tighten them down 1/2 - 1 turn at a time in an outer-outer-inner cap sequence. Could you help me out on this.
Thanks
Paul