Oops, That number for the All Balls seal and bearing kit was 22-1053. Tried the bearings last night and was disappointed. The seals will work fine, The bottom race might be a couple of thousants tight, but should go in cold. The ID of the bottom bearing is about 0.003 in smaller than th OEM. It might drive on ok after I polish the stem surface real well. Now the top bearing. The race seems like it will go in fine but the id of the bearing is over 0.040 in smaller than the od on the stem mating surface. There was a third bearing in the set. It looks like a sealed ball bearing with a snap ring in a groove in the race. It did not fit anything. I have pictures I'll post later today. I was going to try to verify some of those numbers for you but I got so bummed out I just left it for the night.
