Quick update:
Dial indicated output shaft total run out.003
Dial indicated rear wheel left to right out .040
vertical out the same .40
Checked the front end...solid no movement
Removed rear wheel and shocks zero play in the swing arm.
I took some measurements before taking it down.
I have always adjusted the chain with a dial indicator measuring the gap from the rear hollow of the swing arm to the front edge of the adjuster. Tonight I measured from the center line of the rear axle to the center line of the swing arm shaft and think I may have found something. The dr side measurement is 22 1/8" the pass side measurement is 21 7/8". In other words the rear tire is cocked to the dr side...would that not create a right hand push?? I am going to re-adjust to make those two center line distances match.
What do ya'll think? and is the wheel at .040 out enough to cause me problems? Thanks a ton guys.
