So, I pulled my wheels off today so I can take them in for new skins on Monday. I slapped the digital micrometer on my rotors. The rear is still good at about 5.8mm (I don't use the rear that much). The front is at about 4.4mm. Now the manual says 5.0mm standard (new?), 4.5mm service limit for thickness. Is there any fudge factor in that or should I just go ahead and order up a rotor?
I'd rather not replace the rotor until I absolutely have to since I'm holding out hope of finding a TBS wheel. My pads still have plenty of life on them. That said, I'm getting ready for the big California trip next month and the last thing I need is a major repair on the road.
