Here's a video I took with my digi camera of my new Wiseco Pistons moving in the bores. Note that this is in a Bonnie, which has a 360 degree motor so the pistons rise/fall together. If this were a Speedy/America they would move differently...
You know sweat, you can turn the motor over with a big allen wrench when it is on the jack? You guys musta looked pretty funny pushing the bike down the driveway and working the camchain. Good luck with it and keep us posted.
A word to the wise is not necessary. It is the stupid ones who need the advice.
Pat
Yeah I know...the jack was under a bunch of junk...but yeah I look funny anyway, much less pushing a bike with my left hand on the handlebar clamp and my right hand working the cam chain.
I put the old wristpin from a stock piston on a length of MIG wire and ran the cam chain over it. I just had to keep the chain from slipping off the sides. You can see the wristpin at the beginning of the video.
There is no greater thrill than being shot at with no consequence. -Churchill
