OK, I installed the new plugs this morning. While riding in to work, she just dies again. I was able to get onto a median. No instant restart. Messed around a little bit and she started. Since I was more than half way to work I continued onward. She died again. I had to pull over to the side of a four lane road. Again, no instant restart. After I got it started I noticed this happened after I cycled the key off and on. I decided to continue to my place of employment hoping she might die again so that I could just cycle the key and see if this triggered the restart. Of course Mrs. Robinson was uncooperative and didn't die the rest of the way in. She did however backfire a few more times after a brief stall. This has really got me scratching my knoggin. Could it be be the ignition module? When she runs, she seems to be running smoothly even when idling. I am getting some small backfiring when I decel. I am not to worried about this as I figure on tweaking and balancing the carbs when I get this problem figured out. My settings are similar to what they were when she was running fine last summer. I have the Epco's with the screws out 3 turns. I can't remember the jetting but I did put in the ones recommended by someone on this board last year when I did that. Unfortunately I can't search the old board to see what I had done. Any ideas?
