OK guys - I need your help. I got my new bars and redid the wiring this weekend. Got it all done much easier than first time (or so it appeared). Looks really sweet. I put it all back together and tested everything. Turn signals…left, right, back, front – yes. Brake lights – front, rear – yes. Clutch light, oil light, horn – yes. Tach, speedo – yes. License plate light – yes.
Head light…nothing at all also no hi/lo beam light. Arse ! Start up……click…nothing. Bollocks !
I check fuses and the 10 amp (if I remember correctly) for the hi/low beam switch is blown and keeps blowing every time I switch ignition on. All other fuses are fine. Try start again…click...nothing.
My quick diagnosis I managed to do before having to leave the garage and go in the house lest I should kill someone……I may have wires mixed up for starter and hi/lo beam ? Would that cause these symptoms ???? I look at the wiring diagrams in my Haynes and I have to admit I find it hard to follow them in any way to help me with this. All I know is I have about 8 wires clutch side, 6 throttle side – spliced and re-connected in the headlight bucket but the wring diagrams obviously have much more detail and connect the entire system and it looses me.
Any help, advice, direction, best guesses, fingers to the wind….greatly appreciated.
