Quote:
Nice Benny - thanks man. Can you help me understand what you mean by you...
Quote:
...finagled the shrink wrap and the stainles water heater hose so I could still see the original wire while splicing it back up to the connector.
You lost me on the 'finagled' thing 
Quote:
I wish I had thought ahead to slide a grommet onto the bundle before splicing the connector back on! Would have been nice n clean.
Yes - I have a nice, simple black, rubber grommet that'll work perfectly for the job.
Thanks again for the advice.
Steve
What I meant was after I got the wires pulled thru, I exposed the original wires so I could see which color wire was which (since I used all the same color wire as extensions). So I had kinda squished the SS mesh up, etc. I think I shrink wrapped part of the wires, then slid more not-yet-shrinked wrap up over that, once I finishes slicing, I then slid it down and shrunk it. Clear as mudd?
And yeah, go read that write up
As for the Grommets, I'd still do two holes, and two gromets.
Benny
Black & Silver '02
Too many mods to list
Not enough miles ridden
| 
