Quote:
I'll go out on a limb and suggest a set of allens made for a 3/8 drive ratchet wrench. This usually has enough oomph, if not can be used with an impact driver, and you can use a torque wrench to tighten the fastener to the correct spec. How do you do that with a "L" shaped allen?
Geoff
From the "Tech Vault":
Take a 1/2"X 1 1/2" or thereabouts bolt, thread a couple of nuts on, tighten them really tight, (use some red locktight if you like), and you have an axle tool to use with a 3/4" socket. 1/2" bolt works because 3/4" and 19mm are so close, there's really no difference.
Contra todo mal, mezcal; contra todo bien, también
| 
