Bonneville America Forums Forums Technical Forums Accessories OEM BA light bar instructions

I am looking for the OEM BA light bar installation instructions. Anyone out there able to help? I have Brent’s light bar, but want to not mess up the stock wiring. I bought the OEM light bar wire harness and want to adapt it to Brent’s light bar.

Here's a link to a schematic that one our finest made (Jay): schematic

It might be of some use. I think somewhere in the Vault is a schmetic/drawing of the fuse block.

The OEM instructions don't say much...the schematic by Jay is definitely more useful.

Brad
thanks for the link. So much going on with this site it is hard to keep up with all the posts.

It sounds like you're going to be doing the same project that I want to do on my TBA. I like the Rivco lightbar system better than the OEM lightbar but I don't want to get into too much custom wiring. I'm considering getting the harness and adapting it too. Please document your project if possible with digital pictures and post it on the board for the greater good if possible!

Randy
I had not thought about it, but it is as good as done when I get to it. I am not sure if I will do it before this winter or not, but will take the photo's and do a step by step of what I do (hopefully not too many mistakes )