Bonneville America Forums Forums Technical Forums General Tech Re: O2 sensor removal.....

Does anyone know the name for the type of electrical connector used to plug the o2 sensor wiring into the main harness.
Apart from being a pain to get at, up there behind the horn, I'm running out of undamaged fingers trying to get the connection apart....if I had three hands it'd be fine...but I don't.
I'd reckon if I knew what these connectors are called ( I've called them a few names already this morning) I could see if there's a removal tool available.
Thanks.

I do not know the name/style of the connectors but I did remove the fuel tank for best access to them when I removed mine.

Thanks...problem now sorted and I still have all my fingers.
I did take the tank off at first but it didn't seem to offer me much improved access.....so it went back on again.
At present I've left the factory o2 stuff on the bike as I've heard tales that the ecu can figure out its being fooled by the new resistors in circuit and may then show a fault light....if it's not wised up to the change in a few days I'll remove the old setup completely