|
|
 Motion pro clutch tool
|
Joined: Mar 2012
Posts: 262
Adjunct
|
OP
Adjunct
Joined: Mar 2012
Posts: 262 |
Im venting, this tool is the biggest POS! Thats all.
"Get busy living or get busy dying. That's ****** right."-Red
|
|
|
Re: Motion pro clutch tool
|
Joined: Feb 2008
Posts: 2,671 Likes: 15
Loquacious
|
|
Loquacious
Joined: Feb 2008
Posts: 2,671 Likes: 15 |
Could it possibly be worse than the Triumph clutch alignment tool?
|
|
|
Re: Motion pro clutch tool
|
Joined: May 2010
Posts: 5,720
Check Pants
|
|
Check Pants
Joined: May 2010
Posts: 5,720 |
All I do reassemble and constantly check for the throwout to stay loose as I wind the fasteners in. Am I missing something here, Ah doan need no stinkin tool. Should I get one? I want to be one of the cool kids too. 
|
|
|
Re: Motion pro clutch tool
|
Joined: Feb 2008
Posts: 2,671 Likes: 15
Loquacious
|
|
Loquacious
Joined: Feb 2008
Posts: 2,671 Likes: 15 |
Quote:
...Am I missing something here, Ah doan need no stinkin tool. Should I get one? ...
Ryk, you're the coolest kid I know 
|
|
|
Re: Motion pro clutch tool
|
Joined: Oct 2007
Posts: 1,160
Learned Hand
|
|
Learned Hand
Joined: Oct 2007
Posts: 1,160 |
I didnt use a alignment tool ether and I made one so I could tight every thing down.
Life need a little Triumph!
2008 Triumph Speedmaster, Single baffle drag pipes, lots of black powder coatin,K&N pods, AI removed, TBS needles and a procom cdi.
|
|
|
Re: Motion pro clutch tool
|
Joined: Jan 2005
Posts: 1,204
Learned Hand
|
|
Learned Hand
Joined: Jan 2005
Posts: 1,204 |
After two broken clutch plates, I gave the Triumph tool away and tightened everything down in 10 minutes with a ratchet wrench and a 8" aluminum pry bar. It was just that easy.
Last edited by angelis745; 05/22/2016 11:59 PM.
1200CC BIG BORE, W/WISECO PISTONS,.250 STROKED CRANK, PORTED/POLISHED HEADS AND LARGER VALVES, CUSTOM WELDED EXHUAST, DUAL 42MM MIKUNI CARBS.
|
|
|
|
|
|
|
