Bonneville America Forums Forums Technical Forums Exhaust de-baffeling ?

Morning everyone...I'm ready to start removing the baffels from a set of stock tapered exhaust from a 07 TBA.When looking in the inlet side/header side I can see a small dowel pin holding in what appears to be some kind of mesh.Should this stay in, or be removed also? What is it,I didn't think the 07 TBA had a catalytic converter.Any ideas? By the way ,I'm removing "2" baffels.Thanks Again!

I think they are cats, but I dont remember a pin thing. (my 07 had cats) I drilled from the exit of the pipes with an extended hole saw, 3 sets of baffels I think, I then drilled through the cats from the front later, removing the cats made no difference to the noise that I could tell so you could leave them in.

Sorry for quality.
Cats and baffels drilled out.

Thanks NIbiker...I Think for I'll leave the cats in place and remove them later if I deceide to drill out the third baffle. Ride Safe!