Check out the new Gallery
wicked red 1100
wicked red 1100
by mag10, August 21
Windshield I need to replace
Windshield I need to replace
by philwarner, May 10
first ride
first ride
by NemoJr, April 1
Steve McQueen inspired
Steve McQueen inspired
by Feral, November 28
GaRally22
GaRally22
by chy, September 18
Previous Thread
Next Thread
Print Thread
Shift Linkage Installation and Adjustment?
#465063 09/28/2011 7:48 PM
Joined: Jun 2006
Posts: 1,382
lylesdo Offline OP
Learned Hand
OP Offline
Learned Hand
Joined: Jun 2006
Posts: 1,382
Warren (AngusPT) graciously sent me a shift linkage (Thank you Warren, you are a class act!). My only issue is I can't seem to get it back on right, the shifter is sitting way too high. Is there a right way to do this?


'06 TBA - Black, AI and Snorkel removed, K&N Drop In, Gutted Stock Pipes, 145/42, 2 turns out.
Re: Shift Linkage Installation and Adjustment?
lylesdo #465064 09/28/2011 7:53 PM
Joined: Feb 2007
Posts: 23,243
Likes: 64
Fe Butt
Online Content
Fe Butt
Joined: Feb 2007
Posts: 23,243
Likes: 64
If you mean the threaded rod just start both ends at the same time and thread in evenly until the pedal is where you want it. If not enough adjustment you can remove the lever from the shaft coming out of the primary and move it a couple teeth and then adjust the rod again to fine tune.

If the control mount is bent back or the shaft coming out of the primary ir bent forward the pedal will seem too high.


I learned all I need to know about life by killing smart people and eating their brains.
Eat right ,Exercise ,Stay fit, Die Anyway!
Re: Shift Linkage Installation and Adjustment?
The_Dog33 #465065 09/28/2011 7:55 PM
Joined: Jun 2006
Posts: 1,382
lylesdo Offline OP
Learned Hand
OP Offline
Learned Hand
Joined: Jun 2006
Posts: 1,382
Thanks Ian, I'll go give it a try.


'06 TBA - Black, AI and Snorkel removed, K&N Drop In, Gutted Stock Pipes, 145/42, 2 turns out.
Re: Shift Linkage Installation and Adjustment?
lylesdo #465066 09/28/2011 8:09 PM
Joined: Jun 2006
Posts: 1,382
lylesdo Offline OP
Learned Hand
OP Offline
Learned Hand
Joined: Jun 2006
Posts: 1,382
That did the trick! I was starting one side then backing it out into the other side, which was obviously wrong.


'06 TBA - Black, AI and Snorkel removed, K&N Drop In, Gutted Stock Pipes, 145/42, 2 turns out.
Re: Shift Linkage Installation and Adjustment?
lylesdo #465067 09/28/2011 8:10 PM
Joined: Feb 2007
Posts: 23,243
Likes: 64
Fe Butt
Online Content
Fe Butt
Joined: Feb 2007
Posts: 23,243
Likes: 64
Glad it helped


I learned all I need to know about life by killing smart people and eating their brains.
Eat right ,Exercise ,Stay fit, Die Anyway!

Moderated by  bennybmn, chy, mert 

Link Copied to Clipboard
Powered by UBB.threads™ PHP Forum Software 7.7.4