Hi Folks. I needed to get my wife some floorboards and relocation arms for her riding comfort and ability to clear the saddle bags.
Besides the fact that Rivco used imperial rather than metric fasteners, I changed out the hardware to stainless steel and metric except for one cap bolt that goes into a tapped hole (just changed the bolt to stainless on that one).
Fit and finish seem pretty good, but the instructions were a little off. There's pins that are used place the arms and floorboards, and it wasn't that hard to figure out which ones to use, as long as they are 180* apart.
Long story short, my wife likes them, and her legs don't touch the saddle bags. They don't bother me when I put my foot down either. They are heavy.. about 9 lbs, but are pretty solid.
[image]
[/image]
[image]
[/image]
[image]
[/image]
[image]
[/image]
H.
