Check out the new Gallery
wicked red 1100
wicked red 1100
by mag10, August 21
Windshield I need to replace
Windshield I need to replace
by philwarner, May 10
first ride
first ride
by NemoJr, April 1
Steve McQueen inspired
Steve McQueen inspired
by Feral, November 28
GaRally22
GaRally22
by chy, September 18
Previous Thread
Next Thread
Print Thread
03 BA tachometer location
#3041 02/02/2005 5:16 PM
Joined: Jan 2005
Posts: 97
Member
OP Offline
Member
Joined: Jan 2005
Posts: 97
OK, I have gone through the forums and tech archives and havnt found the thread I was looking for. I got curios today and started up the BA just to wet my apetite, we still have ice in front of the shed.I was polishing the tank and my fingernail caught the lip of the triumph emblem, this is on an 03 BA. I pried up the emblem, just curios of course, and it poped off, exposing several wiring harnesses. When I went to replace it I noticed that one of the little clips broke off, its only plastic. This is alright because now I can justify putting a tack on the bike, which I have wanted to do since I purchased it, only now I am confused. I thought that that was the location for the tach but in reading posts and looking at the handbook it is ment for the clock. Am I wrong , will I have to install a clock on my BA . Thats ok to, but if thats not the tach locatio, where is it supposed to go and what are all the wiring harness hookups for. Thanks


Larry
Re: 03 BA tachometer location
wantoride #3042 02/02/2005 5:49 PM
Joined: Jan 2005
Posts: 7,643
Monkey Butt
Offline
Monkey Butt
Joined: Jan 2005
Posts: 7,643
I believe Larry, that you can either install a tach or a clock it just depends on what takes your fancy. I havent installed either, but will be looking to install the tach there in the future with a clock somewhere else.


Ray(UK)
Re: 03 BA tachometer location
wantoride #3043 02/02/2005 6:55 PM
Joined: Jan 2005
Posts: 9,223
Big Bore
Offline
Big Bore
Joined: Jan 2005
Posts: 9,223
Hey Larry,

It will take either tach or clock. On yours, it's literally plug and play. Remove the three bolts holding the console, align and slide the tach in, bolt it down, plug it into the harness, and re-fasten the console. Should take about 15 minutes with a beer break...


"Never underestimate the power of human stupidity" - Robert Heinlein
Re: 03 BA tachometer location
bonnyusa #3044 02/02/2005 7:09 PM
Joined: Jan 2005
Posts: 97
Member
OP Offline
Member
Joined: Jan 2005
Posts: 97
Phil, I think the thread I was looking for was yours, the beer break thing sounds familiar.It shouldnt be hard. After looking on the bonnevile home page, cant think of the name of the parts and accesory dealer but it showed both the clock and tach in the same spot. Thanks Phil and Ray, when Im streching the job with a beer [ so I dont have to go in] Ill think of yall.Ill drink 2 a guiness and a pabst wadda ya think?


Larry
Re: 03 BA tachometer location
wantoride #3045 02/02/2005 7:48 PM
Joined: Jan 2005
Posts: 4,074
Likes: 83
chy Offline
Loquacious
Offline
Loquacious
Joined: Jan 2005
Posts: 4,074
Likes: 83
At first I really wanted a tachometer but in early '02 the things were on back order, it's a good thing though because I've grown quite attached to the badge on the console.

Re: 03 BA tachometer location
bonnyusa #3046 02/02/2005 8:53 PM
Joined: Jan 2005
Posts: 3,954
Loquacious
Offline
Loquacious
Joined: Jan 2005
Posts: 3,954
"a beer break"
I must be getting lazy in my old age, I can't finish ANY job, even the five minute ones, without at least 2 beer breaks!!!!

Re: 03 BA tachometer location
chy #3047 02/03/2005 3:04 PM
Joined: Jan 2005
Posts: 11,126
Likes: 13
moe Offline
Should be Riding
Offline
Should be Riding
Joined: Jan 2005
Posts: 11,126
Likes: 13
Chy, Triumph offered a tach in early 02? Heck I thought they only offered the overpriced clock back then. I am thankful that I didn't order the clock as the tach would have been purchased and the clock sold for a pittance of its original cost.


Blowing gravel off rural roads

Moderated by  bennybmn, chy, mert 

Link Copied to Clipboard
Powered by UBB.threads™ PHP Forum Software 7.7.4