Bonneville America Forums Forums Technical Forums General Tech Carb Synch

Read in the form the other day that some made there own carb synch? I would like to make my own! But need some info on it? Money is tight don't have 80 plus $$$ to buy one!!!! It doesn't look like a complicated device???? I am mechanically inclined but need some info on how to make one??? I haven't seen one in person or up close or I would have an idea on how to make it!! Just seen them on the internet!!! And for as much as you use them 80 plus $$$ is to much $$$ for me to spend (SO THE WIFE) says!!!!!!

I made my own. Cost about $8.

I will post a pic later today if I can find it.

I have packed up most of my workshop ready for a move.

Quite a few on the forum use homemade ones.

You need a yard stick,zip ties,clear plasic tube,I use 2 stroke oil, and some guys have put a small valve at the bottom of the loop. I use one too. How to page

I use 2 stroke oil because if you are way out and suck some in the cyl. the 2 stroke oil will just burn off with no harm. The small valve at the bottom allows you to hook up the tool,start the bike and then slowly open the valve to eliminate sucking anything in the engine because you have control over the liquid.